Norwood The Grain Handler 8 Operator's Manual page 58

2. Pull the "U-Trough Unloading Auger Flighting" 42 out
from the "U-Trough" 2 approximately 6"-8".
# 3-38)
42
Fig. # 3-38 Horizontal Powerhead Installation Step # 2
3. Support the "Horizontal Powerhead" 43 near the end
of the "U-Trough Unloading Auger Flighting" 42 .
Fig. # 3-39)
Fig. # 3-39 Horizontal Powerhead Installation Step # 3
3 - INSTALLATION
(See Fig.
2
(See
42
43
4. Temporarily remove the (Qty. 2) "1/2-13 X 3 Bolts" 45
, & "1/2-13 Nuts" 46 . Align the holes of the "Horizon-
tal Powerhead Output Shaft" 44 with the "Crossbolt
Holes" in the input shaft of the "U-Trough Unloading
Auger Flighting" 42 .
46
Crossbolt
Holes
Fig. # 3-40 Horizontal Powerhead Installation Step # 4
5. Apply Anti-Seize to the "Horizontal Powerhead Output
Shaft" 44 .
(See Fig. # 3-41)
Fig. # 3-41 Horizontal Powerhead Installation Step # 5
3-18
(See Fig. # 3-40)
45
44
Crossbolt
Holes
42
44