Norwood The Grain Handler 8 Operator's Manual page 52

2. The "Power Sweep Stop" should be mounted just to the
left (Counterclockwise) of the door.
3. The "Power Sweep Stop" should be installed 1-1/8" from
the bottom of the mounting plate to the grain bin floor for
the Standard Drive Wheel option.
Fig. # 3-28 Power Sweep Stop Mounting Location
4. Use 3 bolts to attach the sweep stop to the bin wall. Install
the spring between the two small holes as shown and
check to insure that the stop springs back out after folding
it in. If the stop doesn't function properly please contact
your dealer and resolve any problems before putting the
power sweep into service.
Move To
"Operating
Position"
Fig. # 3-29 Power Sweep Stop "Operating Position" &
Stopped Position"
3 - INSTALLATION
5. The "Power Sweep Stop" should be installed 5-1/2" from
1-1/8"
"Stopped
Position"
Shown
3-12
the bottom of the mounting plate to the grain bin floor for
the BuzzWheel option.
Fig. # 3-30 Power Sweep Stop Mounting Location
5-1/2"