Power Sweep Stop Installation - Norwood The Grain Handler 8 Operator's Manual

Power Sweep Stop Installation

The Power Sweep Stop is intended to stop the Power Sweep
near the door so that it is conveniently located for the next use.
Use the following instructions to install the Power Sweep Stop.
DANGER
The "Power Sweep Stop" IS NOT intended as a device to
allow persons to enter the bin while the unit is in operation.
ROTATING AUGER HAZARD KEEP AWAY
To prevent serious injury or death from rotating
augers:
1. Do not enter bin unless power is locked out.
2. Turn machine OFF, shut down and lock out power
source, unplug power cord and wait for all moving parts
to stop before inspecting, servicing or repairing machine.
3. Keep body, hair, and clothing away from moving parts.
4. Stay away from rotating augers. Keep others away.
FAILURE TO HEED THIS WARNING MAY CAUSE
SERIOUS INJURY OR DEATH.
DANGER
NEVER ENTER BIN UNLESS ALL POWER IS LOCKED
OUT AND ANOTHER PERSON IS PRESENT.
Exposed auger and moving parts can cause severe in-
jury or death. Rotating augers are dangerous! Flowing
grain may trap and suffocate.
FAILURE TO HEED THIS WARNING MAY CAUSE SERI-
OUS INJURY OR DEATH.
3 - INSTALLATION
1. Rotate the "Power Sweep Assembly" 27 and locate it
in front of the "Hoppers" 33 in the grain bin floor.
Fig. # 3-27)
27
Fig. # 3-27 Rotate Power Sweep Assembly In Front Of The
3-11
33
33
Hoppers
(See
33