Norwood The Grain Handler 8 Operator's Manual page 67

If your Power Sweep has no "Drive Wheel Flighting Ex-
tension" installed, then proceed to Step # 9
# 3-30)
3. Rotate the "Power Sweep" 1 so it is centered on the
"Doorway" 2 of the grain bin. Using a "Hand Truck"
3 will make this easier.
Fig. # 3-66 Center Power Sweep On Doorway
4. If the "Power Sweep Stop" is in the path of rotation, then
disengage it by moving Sweep Positioner to the "Operat-
ing Position" (Shown with Standard Drive Wheel Option
Installed) (See Fig. # 3-67)
NOTE
(See Page
3 - INSTALLATION
Move To
"Operating
Position"
Fig. # 3-67 Disengage Power Sweep Stop
5. Lift up the end of the "Power Sweep" 1 and place it on
a "Sawhorse" Or Equivalent Support Object" 2 . The
"Power Sweep" 1 uses a "U-Joint" 3 at the "Center
Hopper Sump" 4 which allows it to rotate upward.
Fig. # 3-68)
2
3
1
Fig. # 3-68 Support The Power Sweep End
3-27
1
2
Move Power
Sweep To
Doorway
(See
3
4