Ip Via Setting - Codec Tieline Gateway User Manual

234 Gateway and Gateway 4 Manual v1.2

IP Via Setting

24.3
When dialing over IP you can select the preferred interface to use when establishing a connection.
By default Any is selected, which means the first available interface will be used to dial a
connection. The default Via interfaces in order of use when available are:
1. LAN1 Ethernet port (default Primary Via interface)
2. LAN2 Ethernet port (default Secondary Via interface)
3. Wi-Fi (default Tertiary Via interface)
Important Notes:
· If an interface is not available it is not listed in the Via interface selection screen. E.g. if
Wi-Fi is not configured it will be unavailable.
· VLAN interfaces have features similar to physical Ethernet interfaces. However, your
network administrator will need to configure VLAN support throughout your network for
them to be supported in your codec.
Reconfigure Default Primary, Secondary and Tertiary Interfaces
It is possible to reconfigure the default Primary (Ethernet 1), Secondary (Ethernet 2) and Tertiary
(Wi-Fi) interfaces in the codec. As an example, you may want to select Primary as the dialing
interface in a program and then copy this program onto multiple codecs. However, the actual
primary interface used at each location can vary for each codec. For one codec it may be an
Ethernet port and for another it may be a Wi-Fi interface. This allows you to configure site-specific
settings to suit available network interfaces at different remote locations.
1. Press the SETTINGS
2. Use the navigation buttons to select IP Options and press the
3. Navigate to IP Via Setup and press the
4. Navigate to the Primary, Secondary or Tertiary IP Via interface setting and press the
button.
5. Select an alternative default interface and press the
button.
button.
button.
button.
© Tieline Research Pty. Ltd. 2021