Codec Tieline Gateway User Manual page 123

Important Notes:
· If you select Sessionless as the Session Protocol select UDP/IP +RTP for RFC-
compliant IP streaming.
· See
Relays and RS232 Data
7. Configure destination codec dialing and encoding settings:
For IP connections configure the IP address, ports, and then specify which streaming
interface is used to dial this connection, e.g. Primary (port LAN1) or Secondary (port
LAN2). Note: By default Any will select LAN1 if it is available and LAN2 if it is
unavailable.
If TieLink Contact List dialing is configured:
© Tieline Research Pty. Ltd. 2021
RS232 Data Configuration
for more information on relay operations.
Important Note: The Remote Audio Port is the codec port at the remote end
of the link to which you are sending audio. The Local Audio Port is used by
the local codec to receive audio from the remote codec. When Tieline Codecs
is the Session Protocol selected (using Tieline session data), the default port
value for the Local Audio Port is Automatic. Note: Automatic indicates that
the codec will arbitrarily allocate the local port value and send this information
to the codec to which you are dialing. Click to deselect the Automatic check-
box and change this setting. When you select Sessionless as the Session
Protocol, the Session Port is not configurable and you can manually
configure the Remote Audio Port and Local Audio Port.
1. Click the Address Book
Address Book.
Gateway and Gateway 4 Manual v1.2
for detailed information on RS232 data and see
button to select a contact to dial from the TieLink
123
Enabling