Codec Tieline Gateway User Manual page 231

To adjust this setting:
1. Press the SETTINGS
2. Select Transports and press the
3. Use the down
4. Select Configuration and then IPv6 Mode and press the
5. Select Auto, Manual or Off and press the
6. Press the Return
button to confirm the new settings.
By default the codec is configured to allow the codec to automatically receive IPv6 address
information from an IPv6 enabled router.
Manual IPv6 Address Assignment
Select Manual mode using the previous procedure and enter information into the IPv6 Address,
IPv6 Prefix Size and IPv6 Gateway fields in the codec to manually configure address details.
DNS Server
It is possible to specify Domain Name Server (DNS) settings to allow easy look up of codecs within
the specified DNS Addresses or Domains section within the Web-GUI. This feature can be turned
on or off in the LAN codec menu.
1. Press the SETTINGS
2. Select Transports and press the
3. Use the down
the
4. Select Configuration and press the
5. Use the down
6. Press the
7. Enter DNS Address and Domain details as required.
8. Press the Return
button to confirm the new settings.
Link Mode Configuration
It is possible to configure the Ethernet link speed (10/100/1000/Auto) and whether each interface will
operate in Full-Duplex or Half-Duplex modes.
1. Press the SETTINGS
2. Select Transports and press the
3. Use the down
the
4. Select Configuration and press the
5. Use the down
6. Press the
7. Press the Return
button to confirm the new settings.
© Tieline Research Pty. Ltd. 2021
button.
navigation button to select LAN1, LAN2 or a VLAN interface.
button, then select Save in the confirmation dialog and press the
button.
navigation button to select LAN1, LAN2 or a VLAN interface, then press
button.
navigation button to scroll to Set DNS.
button to toggle between Auto and Manual.
button, then select Save in the confirmation dialog and press the
button.
navigation button to select LAN1, LAN2 or a VLAN interface, then press
button.
navigation button to scroll to Link Mode.
button to select a preferred setting. Note: Default setting is Auto.
button, then select Save in the confirmation dialog and press the
Gateway and Gateway 4 Manual v1.2
button.
button.
button.
button.
button.
button.
button.
231