Codec Tieline Gateway User Manual page 221

23.36.1 Rule Examples
Load a New Matrix on a Remote Codec
Rules can be configured to load different custom matrices in a codec on demand. There is also a
solution to allow a studio codec to activate a remote codec matrix change:
1. On the studio codec, create a program and configure a new rule with Use a local input to
toggle a remote output and then configure a local input (e.g. Local Control Port Input 1)
to activate a remote output (e.g. Remote Output 2).
2. On the remote codec, configure a new rule with Use an input to load a custom mix and
for the Input select Remote Input and the same Remote Output number as configured
previously on the studio codec rule (e.g. number 2 in this example).
It may seem a bit counter-intuitive to select a Remote Input in the rule on the remote codec to
perform the matrix change, which is actually referring to the Remote Output at the studio codec,
but this is correct.
© Tieline Research Pty. Ltd. 2021
Gateway and Gateway 4 Manual v1.2
221