6.12.1.2. Storing Configurations from the User Presets
Utilities
Store Preset
Cancel
1 to 10
6.12.2. Disabling Preset Recall when the Video Input/Output Standards Change
Utilities
Auto Recall Presets
Enable
Disable
6.12.3. Recall presets via GPIs
The converter modules provide ten user preset areas, which can be recalled via external GPI inputs.
There are four controls that are used to set functions of the GPI inputs. For the sake of brevity, only one
control will be included in this manual.
Utilities
GPI 1
OFF
Recall User Preset 1
Recall User Preset 2
Recall User Preset 3
Recall User Preset 4
Recall User Preset 5
Recall User Preset 6
Recall User Preset 7
Recall User Preset 8
Recall User Preset 9
Recall User Preset 10
GPI settings are also stored in the User Presets in addition to the other settings. If the
GPI settings are not the same when a configuration is recalled using a GPI, unexpected
results may occur. In other words, make sure your GPI settings are the same for
each User Preset.
This control is used to initiate a store of the current card configuration into
one of the user presets.
Use the toggle switch to select the preset location where you want to store
the module configuration. After selecting the preset, you must press the
pushbutton before the store will take place. You can abort the operation by
pressing the pushbutton when Cancel is displayed.
This control is used to enable or disable the recall of parameter store with
each input and output combination. Each input and output combination
stores all the card parameters. During any standard change, the set is
recalled.
This control is used to set which preset will be recalled when the
respective GPI input is closed to ground. To disable a GPI input set it to
Off.
Revision 1.0
7710XUC-HD HD Format Up/Down/Cross Converter
7700 MultiFrame Manual
7710XUC-HD
-47