Service Access Control - ZyXEL Communications GS1915 Series User Manual

Table 136 Management > Access Control > Logins (continued)
LABEL
Retype to
confirm
User Name
Password
Retype to
confirm
Privilege
Apply
Cancel

32.5 Service Access Control

Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure "trusted computers" for each service in the Remote
Management screen (discussed later). Click Access Control to go back to the main Access Control
screen.
Figure 192 Management > Access Control > Service Access Control
Chapter 32 Access Control
DESCRIPTION
Retype your new system password for confirmation.
Set a user name (up to 32 single-byte printable characters long).
Enter your new system password.
Retype your new system password for confirmation.
Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 – Display basic system information.
• 3 – Display configuration or status.
• 13 – Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 – Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he or she can run commands that
requires privilege level of 5 or less but not more.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1915 Series User's Guide
266