Static Arp - ZyXEL Communications XS1930-12HP User Manual

Figure 199 IP Application > ARP Setup > ARP Learning
The following table describes the labels in this screen.
Table 143 IP Application > ARP Setup > ARP Learning
LABEL
Port
*
ARP Learning
Mode
Apply
Cancel

34.2.2 Static ARP

Use this screen to create static ARP entries that will display in the Management > ARP Table screen and
will not age out. Click the link next to Static ARP in the IP Application > ARP Setup screen to display the
screen as shown.
Chapter 34 ARP Setup
DESCRIPTION
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select the ARP learning mode the Switch uses on the port.
Select ARP-Reply to have the Switch update the ARP table only with the ARP replies to the ARP
requests sent by the Switch.
Select Gratuitous-ARP to have the Switch update its ARP table with either an ARP reply or a
gratuitous ARP request.
Select ARP-Request to have the Switch update the ARP table with both ARP replies, gratuitous
ARP requests and ARP requests.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS1930 Series User's Guide
278