Mld Snooping-Proxy Filtering - ZyXEL Communications GS1920v2 Series User Manual

Table 115 SWITCHING > Multicast > IPv6 Multicast > Port Role Setting (continued)
LABEL
Leave Timeout
Fast Leave Timeout
Apply
Cancel

39.10 MLD Snooping-proxy Filtering

Use this screen to configure the Switch's MLD filtering settings. Click the SWITCHING > Multicast > IPv6
Multicast > Filtering screen to display the screen as shown.
Figure 164 SWITCHING > Multicast > IPv6 Multicast > Filtering
Chapter 39 Multicast
DESCRIPTION
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
GS1920v2 Series User's Guide
236