Teledyne T3LCR1002 User Manual page 94

Remote Control
The USB driver needs to be installed when using the USB
port for remote control. The USB interface creates a
virtual COM port when connected to a PC.
Configure the interface to USB in
SYSTEM>CONFIG>REMOTE item.
Connect the Type A-B USB cable to the rear panel USB
B port on the T3LCR. Connect the other end to the Type
A port on the PC.
Go to the Windows Device Manager.
For Windows 7 go to:
Start Menu > Control Panel > Hardware and Sound >
Device Manager
The T3LCR will appear as an unknown LCR Meter
Right-
select the USB VCP Drivers.
The T3LCR and the converter that it is assigned to will
now appear in under the Controller (Universal Serial Bus
Controller) node.
92
1.800.561.8187 information@itm.com
www. .com