Teledyne T3LCR1002 User Manual page 92

90
1.800.561.8187
Pin 2: RxD
Pin 3: TxD
Pin 5: GND
Pin 1, 4, 6-9: No Connection
T3LCR
Pin2 RxD
Pin3 TxD
Pin5 GND
Make sure the controller you connect to T3LCR Series
also uses these settings. The RS-232 interface transfers
data using:
Data bits: 8 bits
Stop bits: 1 bit
Parity: none
Baud rate: 1200-115200bps
You can connect a controller (i.e. PC and PLC) to the
USB interface using a type A-B USB cable.
This virtual port can perform the same functions as
RS232 and use the same settings as the RS232 port. It
supports USB2.0 and below version.
The USB device port on the rear panel is used for remote
control. The USB port is configured as CDC interface.
When configured to CDC, the USB port on the T3LCR
series will appear as a virtual COM port to a connected
PC. Any terminal program that can communicate via a
serial port can be used for remote control. Before the
T3LCR series can be used for remote control using the
www. .com
Remote Control
PC
RxD Pin2
TxD Pin3
GND Pin5
information@itm.com