Trigger[:Immediate] - Teledyne T3LCR1002 User Manual

The TRIGger subsystem command group is used to enable a measurement or
a sweep measurement, and to set the trigger mode.
The TRIGger:IMMediate command causes the trigger to execute a
measurement or a sweep measurement, regardless of the trigger state.
The TRIGger:SOURce command sets the trigger mode.
The TRIGger:DELAY command sets the trigger delay time.
1.800.561.8187
Command

TRIGger[:IMMediate]

Syntax
Example SEND> TRIG<NL>
Note This command can be ONLY used in BUS trigger mode.
Command
TRIGger:SOURce {INT,MAN,EXT,BUS}
Syntax
Parameter Where, {INT,MAN,EXT,BUS} is
INT
MAN
EXT
BUS
Example SEND> TRIG:SOUR BUS<NL>
Query Syntax TRIGger:SOURce?
Query Response {INT,MAN,EXT,BUS}
Example SEND> TRIG:SOUR?<NL>
RET>
Command TRIGger:DELAY {<float>,min,max}
Syntax TRIGger:DLY {<float>,min,max}
www.
[:IMMediate]
TRIGger
:S OURce
:DELAY(DLY)
Internal Trigger Mode
Manual Trigger Mode
External Trigger Mode
BUS Trigger Mode
INT<NL>
.com
T3LCR Series User Manual
{INT,MAN,EXT,BUS}
<float value>,min,max
123
information@itm.com