Table of Contents
Advertisement
The instrument meets intent of EC Directive 2014/35/EU for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use -
Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use -
Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:
The instrument is subject to disposal and recycling regulations that vary by
country and region. Many countries prohibit the disposal of waste electronic
equipment in standard waste receptacles. For more information about proper
disposal and recycling of your Teledyne LeCroy product, please visit
1.800.561.8187
Mains Supply Connector: Overvoltage Category II, instrument intended to
be supplied from the building wiring at utilization points (socket outlets
and similar).
Measuring Circuit Terminals: No rated measurement category. Terminals
not intended to be connected directly to the mains supply.
Unit: Pollution Degree 2, operating environment where normally only dry,
non-conductive pollution occurs. Temporary conductivity caused by
condensation should be expected.
The instrument is marked with this symbol to indicate that it
complies with the applicable European Union requirements of
Directives 2012/19/EU and 2006/66/EC on Waste Electrical
and Electronic Equipment (WEEE) and Batteries.
www.
information@itm.com
.com
T3LCR Series User Manual
143
Advertisement
Table of Contents
