Teledyne T3LCR1002 User Manual page 93

T3LCR Series User Manual
CDC USB class, install the appropriate CDC USB driver.
Make sure the controller you connect to T3LCR Series
also uses these settings. The USB interface transfers
data using:
PC connector: Type A, host
T3LCR series connector: Rear panel Type B, slave
Speed: 1.1/2.0 (full speed/high speed)
USB Class: CDC (Communications device class)
Hardware flow control: Off
Data bits: 8-bit
Stop bits: 1-bit
Parity: none
Baud rate: 1200-115200 bps
91
1.800.561.8187 information@itm.com
www. .com