Teledyne T3LCR1002 User Manual page 15

This chapter contains general information about T3LCR Series .The
information is organized as follows.
1.800.561.8187
Introduction
Main Specifications
Feature overview
Thank you for purchasing an T3LCR Series LCR meter.
The TELEDYNE T3LCR Series is a general-purpose
LCR meter for incoming inspection of components,
quality control, and laboratory use.
The T3LCR Series is used for evaluating LCR
components, materials, and semiconductor devices over a
wide range of frequencies (10 Hz to 300 kHz) and test
signal levels (10.00mV to 2.00V & 100.0uA to 20.00mA).
With its built-in comparator, the T3LCR Series can
output comparison/decision results for sorting
components into a maximum of ten bins. Furthermore,
by using the handler interface, the T3LCR Series can be
easily combined with a component handler, and a system
controller to fully automate component testing, sorting,
and quality-control data processing.
The list measure function permits entry of up to 10
frequencies or test signal levels points to be automatically
measured.
www.
information@itm.com
.com
T3LCR Series User Manual
13