Teledyne T3LCR1002 User Manual page 89

1.800.561.8187
field using the cursor keys.
Connect the clips to a shorting bar as
7.
shown below:
Press the [MEAS SHORT] soft-key and
8.
then the [OK] soft-key. Wait until the
displayed.
Press the [ON] soft-key if the SHORT
9.
field is set to OFF.
Step 5. Connect the DUT to the test fixture as shown
below:
Step 6. Press the [Measure] key. Measurements are
performed continuously by the internal
trigger, and the measured Cs and D values of
www. .com
T3LCR Series User Manual
message is
87
information@itm.com