Teledyne T3LCR1002 User Manual page 43

1.800.561.8187
Trigger Mode Function
INT
source.
MAN Trigger by pressing the trigger
button.
EXT Trigger by sending a signal to the
trigger pin on the handler interface.
BUS Trigger by the RS-232/USB port.
The list parameter used for the list measurement can be
the measurement frequency or the signal level [V/A].
Use the list point field to specify the list measurement
parameter.
Step 1. Press the [Measure] key.
Step 2. Press the [LIST SETUP] soft-key.
Step 3. Use the cursor key to select FREQ or VOLT
or CURR field.
Step 4. Use the soft-keys to select list measurement
parameter.
Soft-key Function
FREQ Uses frequency as the list
measurement parameter
VOLT Uses voltage as the list measurement
parameter
CURR Uses current as the list measurement
parameter
www. .com
T3LCR Series User Manual
41
information@itm.com