Table of Contents
Advertisement
The LIST:BAND command sets the List Sweep point value, limit mode and
low/high limit values.
118
1.800.561.8187
Parameter
Where,<n> is:
n
Query Response
{on,off}
Example
SEND> LIST:STAT? 1<NL>
RET>
Command
LIST:BAND <n>,<point value>,{A,B,OFF},<low>,
Syntax
<high>
Parameter
Where, <n>,<point value>,{A,B,OFF},<low>,<high>
is:
n
<point value>
or signal level voltage value)
A
parameter.
B
parameter.
OFF
<low>
<high> NR1,NR2 or NR3: high limit value
Note: The suffix multipliers can be used with this
command. But the suffix units CANNOT be added.
Example
SEND> LIST:BAND 1,1k,A,1n,2n<NL>
SEND> LIST:BAND 2,10k,A,1E-9,2E-9<NL>
Query Syntax
LIST:BAND? <n>
Parameter
Where,<n> is:
n
Query Response
{on,off},<point value>,{A,B,-
},<NR3:low>,<NR4:high>
Example
SEND> LIST:BAND? 1<NL>
RET>
9<NL>
www.
NR1(1 to 10): List sweep point
on<NL>
NR1(1 to 10): List sweep point
Sweep point value (frequency value
Uses the primary parameter as the limit
Uses the secondary parameter as the limit
NR1,NR2 or NR3: low limit value
NR1(1 to 10): List sweep point
on,1.00000e+03,A,1.000000E-9,2.000000E-
.com
Command Reference
ction
information@itm.com
Advertisement
Table of Contents
