Teledyne T3LCR1002 User Manual page 87

1.800.561.8187
This paragraph describes a practical example of
measuring a ceramic capacitor.
The basic procedure flow to perform this measurement is
the same as the Basic Measurement Procedure described
previously. In this example, a ceramic capacitor is
measured under the following conditions.
Sample (DUT) Ceramic capacitor Measurement
Conditions:
Function: Cs-D
Test Frequency:
Test Signal Level:
www. .com
T3LCR Series User Manual
Start
Setup measurement
conditions:
[FUNC]
[LEVEL]
[FREQ]
Connect the test fixture
CORRECTIONS
OPEN TEST
SHORT TEST
Connect DUT
Perform measurement
END
1 kHz
1V
information@itm.com
85