Creating The Program Header; Programming The Tool - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Application example
5.8.1

Creating the program header

5.8.2

Programming the tool

HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Tap Create new program in the program management
A dialog box opens.
In the dialog select the storage location, e.g.
Internal/Programs in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Create
A new program containing the start block Program header is
created.
In Name enter the name Example
Confirm the entry with RET
In Unit for linear values select the mm unit of measure
The program has been successfully created; you can then
begin with programming.
Tap Add block on the toolbar
A new block is inserted below the current position.
In the Block type drop-down list, select the Tool call block
type
Tap Tool number
The Tools dialog box appears.
Tap Drill 5.0
The associated tool parameters are applied automatically.
The Tools dialog is closed.
Tap Add block on the toolbar
A new block is inserted below the current position.
In the Block type drop-down list, select the Spindle speed
block type
In Spindle speed, enter the value 3000
Confirm the entry with RET
III
271