Programming MCD for the UC360
This section describes how to program the MCD settings for the UC360.
Refer to the MCD System Administration Tool Online Help for detailed instructions on how
to program SIP Device Capabilities on the MCD system.Only MCD certified technicians should
be programming the UC360 on the MCD.
The UC360 is a SIP device and can is programmed on the MCD. Licensing is also required on
the MCD for the SIP Device. Refer to the UC360 Engineering Guidelines for more details on
licensing.
The information provided below is based on MCD Release 5.0 SP2 PR1 (the minimum MCD
release supporting the UC360) and may change; however, these instructions will still aid you
in programming the UC360 for use on the MCD.
Program the following forms in MCD:
•
"User and Device Configuration" on page 64
•
"SIP Device Capabilities" on page 68
MCD Configuration for the UC360
63