Direct Trunk Select - Mitel SX-5 Manual

SECTION MITL9103 -098 -105-NA
Direct Trunk Select
Description
Selection of this fedure allows an extension user to access a specific trunk by dialing
the assigned trunk access code. Refer to Selectable Numbering Plans, Trunk Group
Operation and Discriminating Ringing.
Conditions
When default data is loaded. SW1 must be set to OPEN to enable Direct Trunk
Select.
The access code for Trunk 2 is dependent on the numbering plan selected. When
numbering plan
1
or 2 is selected, the access code is 8. When numbering plan 3
or 4 is selected. the access code is 7.
The access code for trunk
1
is 9 regardless of the numbering plan selected.
.Feature Selection
To Enable Direct Trunk Select:
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4231
-
acknowledge tone is returned.
Replace the handset
-
the SX-5 operates in the Direct Trunk Select mode.
Set SW2 to CLOSED..
To Disable Direct T ~ n k Select:
Set S W to OPEN.
Lift the Contml Extension hanset
-
dial tone is returned
Dial 4232
-
acknowledge tone is returned.
Replace the handset
-
the SX-5 operates in the Trunk Group Operation mode.
Set SW2 to CLOSED.
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep none
I), indicates that the new feature access code has been
accepted
Two beeps none 2). indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone w i l l be received
when the dialed code is invalid.
Operation
None
Page 26