Data Line Security - Mitel SX-5 Manual

Data Line S e c u r i t y
Description
An extension with this feature enabled cannot receive camp-on tone. A call may be
camped-on to an extension with Data Security, but ail forms of audio intrusion are
prohibited. When Data Line Security is enabled on an extension, it must be noted that:
Incoming Trunk calls do not ring the extension.
Camp-on tone is not received by the extension, or any party connected to the
extension, when an incoming trunk call is present
When call fowarding is set by the same extension the forwarded extension will ring
or receive camp-on tone.
Conditions
This feature should only be enabled when data lines
are
in use (i . e. computer
terminals with modems).
System default data provides no Data Line Security.
Feature Selection
To Enable Data Line Security for an Extension:
Set Programming Switch (SW2) to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 40x92 where X is the Equipment Number of the extension to which Data
Line Security is to be applied
-
acknowledge tone is returned.
Replace the handset
-
Data Line Security is enabled. No audio intrusion
(camp-on tone) is allowed.
Set
SW2
to CLOSED.
To-Disable Data Line Security for an Extension:
Set Programming Switch
(SW2) to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 40x91 where X is the Equipment Number of the extension for which Data
Line Security is to be removed
-
acknowledge tone is returned.
Replace the handset
-
Data Line Security is disabled.
Set SW2 to CLOSED.
NOTES:
1.
Acknowledge tone may be one of two tones; they are:
One beep ilone I), indicates that the new featwe access code has been
accepted.
Two beeps (Tone
2,
indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
2.
The Equipment Number of an extension is defined as the second digit of
the Extension Number. i . e. the EN of extension 23 is 3 .
Operation
Automatic
Page 19