Functional Description; General; Line Select Keys; Line Status Leds - Mitel SX-200 Manual

3. FUNCTIONAL DESCRIPTION

General

Line Select Keys

Line Status LEDs

Speed Dial Keys

Hold Key

Feature Keys

3.01 Figure 3-1 shows the SUPERSET
the face layout is shown in Figure 3-2. A description of the
function of each key and display follows. All keys are noninterlocking.
3.02 During CDE, the three Line Select keys are programmed to
access lines and/or trunks. The leftmost key will access the
set's Prime Line. The remaining two keys are available for use as
Speed Dial keys, if they have not been assigned as line appearances.
3.03 Above each Line Select key there is an associated Line Status
LED. The LED lights continuously to indicate the line is in use; it
flashes to indicate a call is on hold at that line.
3.04 There are 12 Speed Dial keys located on the upper right portion
of the set. The user can program these keys with frequently-
dialed numbers.
3.05 The red Hold key allows the user to place any call at the set on
hold. The Line Status LED associated with the held line, flashes
to remind the user that a call is on hold. The call is retrieved by
pressing the Line Select key.
3.06 Each of the seven Feature keys are associated with a specific
feature. They are as follows:
SWAP - The SWAP key allows the user to alternate between two
established calls (a Broker's Call).
TRANS/CONF - This key allows the user to put a call on hold, dial a
new nu-mber and conference the call or transfer the held call (with
privacy) to the new number.
redialed when the key is pressed.
CANCEL - This key cancels any dialing which had been performed.
PROGRAM/SAVE - This key allows the user to program and save
3 Telephone Description
3 Electronic Telephone Set;
Page 5