Alternator Stator Installation - Segway SNARLER ATV 2021 Series Service Manual

D D
C C
C C
E E
G G
ENGINE-ELECTRICAL SYSTEM ENGINE-ELECTRICAL SYSTEM

Alternator Stator Installation

Alternator Stator Installation
◆ Apply a non-permanent locking agent to the area
A A B B
◆ Tighten:
Torque
◆ Install:
Crankshaft Sensor (see Crankshaft Sensor Installation)
◆ Fit the lead grommets【G】into the notch on the
◆ Fit the Plate 【E】
◆ Apply liquid gasket【H】to mating surface of the
H H
【A】 (12 mm, 0.47 in.) except for the tip【B】(2 ~
3 mm, 0.08 ~ 0.12 in.)
Bolts M6×35
13 N•m (1.3 kgf•m, 113 in•lb)
Bolts M6×16
9.8 N•m (1.0 kgf•m, 87in•lb)
Left Crankcase Cover.
lead grommets.
Sealant:5699
Apply after, must be assembled with in 5 min.
3-3-9