Segway SNARLER ATV 2021 Series Service Manual page 137

Proper Seat Contact
on Valve Face
INTAKE
B B
C C
EXHAUST
E E
A A
A A
B B
D D
A A
B B
C C
NOTE NOTE
When using an interference angle, the seat contact
point on the valve will be very narrow, and is a normal
condition. Look for an even and continuous contact point
all the way around the valve face【A】.
【A】30°
【B】45°
【C】60°
【D】1.0 ~ 1.1mm (0.0394" ~ 0.0433")
Service Limit: 1.4mm (0.055")
【A】 30°
【B】 45°
【C】 60°
【E】1.5 ~ 1.6mm (0.0591" ~ 0.0630")
Service Limit: 1.9mm (0.075")
◆ Clean all fi lings from the area with hot soapy water.
Rinse and dry with compressed air.
◆ Lubricate valve guides with clean engine oil and
apply oil or water based lapping compound to the
face of the valve.
NOTE NOTE
Lapping is not required if an interference angle
reconditioning method is used.
◆ Insert the valve into its respective guide and
lap using a lapping tool or a section of fuel line
connected to the valve stem.
3-5-27
ENGINE TOP END ENGINE TOP END