Segway SNARLER ATV 2021 Series Service Manual page 69

B B
C C
B B
C C
A A
E E
F F
G G
CRANKSHAFT / TRANSMISSION CRANKSHAFT / TRANSMISSION
D D
A A
D D
CAUTION CAUTION
The Driving Bevel Gear【B】and Driven Bevel Gear
【A】are machined at the factory in the assembled
state, so the Driving Bevel Gear and Driven Bevel Gear
must be replaced as a set.
◆ Install:
1. Driven Bevel Gear Assembly【A】
2. Shim,Driven Bevel Gear【D】
3. Bolts M8×35【C】
◆ Tighten:
Torque
26 N·m (2.7 kgf·m, 20 ft·lb)
◆ Apply a non-permanent locking agent to the Bolts
【C】
TIPS TIPS
Driven bevel gear backlash
Standard:0.15 ~ 0.25 mm
◆ Press and insert the bearings until they are bottomed.
Special Tool - Bearing Driver Set Special Tool - Bearing Driver Set
【B】 Ball Bearing : 6305
◆ Install:
Bearing Frame Plate【A】
Screw M8×25【C】
◆ Tighten:
Torque
Screw M8×25【C】
26 N·m (2.7 kgf·m, 20 ft·lb)
◆ Apply a non-permanent locking agent to the Screw【C】
◆ Install:
1. Drive Bevel Gear Shaft,Reduction Driven Gear,Circlip
Combination【D】
2. Drive Bevel Gear Shim【E】
3. Drive Bevel Gear【F】
4. Nut M22×1【G】
◆ Tighten:
Torque
Nut M22×1【G】
180 N·m (18.4 kgf·m, 133 ft·lb)
Apply a non-permanent locking agent to the Nut 【G】
◆
3-2-19
Bolts 【C】