Charging System; Alternator Cover Removal; Alternator Cover Installation - Segway SNARLER ATV 2021 Series Service Manual

ENGINE-ELECTRICAL SYSTEM ENGINE-ELECTRICAL SYSTEM
A A
D D
F F
A A
B B

Charging System

Alternator Cover Removal

Alternator Cover Removal
◆ Place an coolant pan under the engine left side.
C C
◆ Drain the coolant (see Cooling System chapter).
◆ Place an oil pan under the engine left side.
◆ Remove Water Pump (see Cooling System chapter).
B B
◆ Remove:
Alternator and Crankshaft Sensor Lead Connectors
(disconnect)

Alternator Cover Installation

Alternator Cover Installation
◆ Be sure all of the old gasket has been removed from
E E
◆ Check that the Dowel Pins【D】are in place, and fi t
◆ Fit the grommets【C】into the notch in the cover.
◆ Install the Alternator Cover bolts【A】and【B】
◆ Tighten
Torque
◆ Install Water Pump (see Cooling System chapter).
【A】Bolts M6×30 (12)
【B】Bolts M6×55 (2)
【C】Alternator Cover
the alternator cover and the left crankcase sealing
surfaces.
a new gasket【E】on the crankcase.
Alternator Cover Bolts
9.8 N·m (1.0kgf·m, 87 in·lb)
3-3-6