Segway SNARLER ATV 2021 Series Service Manual page 72

CRANKSHAFT / TRANSMISSION CRANKSHAFT / TRANSMISSION
G G
C C
F F
E E
A A B B
D D
C C
B B
A A
◆ Apply a non-permanent locking agent to the area
【A】(12 mm, 0.47 in.) except for the tip【B】(2 ~ 3
mm, 0.08 ~ 0.12 in.).
Right Crankcase Bolt M6×40【13】
◆ Tighten the right crankcase bolts (M6) following the
tightening sequence【1 ~ 13】
Torque
Crankcase Bolts (M6)
9.8 N·m (1.0 kgf·m, 87 in·lb)
[1 ~ 13] L = 40 mm
Left Crankcase : Bolt M8×70【2】
Bolt M8×40【3】
Bolt M6×65【4】
◆ Tighten left crankcase bolts following the tightening
sequence【1 ~ 5】(M8),【6 ~ 9】(M6)
Torque
Bolts (M6)
9.8 N·m (1.0 kgf·m, 87 in·lb) 20 N·m (2.0 kgf·m, 14 ft·lb)
【1 ~ 2】L = 70 mm
【3 ~ 5】L = 40 mm
【6 ~ 9】L = 65 mm
◆ Apply grease to the steel ball【A】,Parking Brake
Pin【E】 and spring【B】【F】.
◆ Install:
Steel Ball【A】
Spring【B】
washer【C】
Shift Spring Plug【D】
◆ Install:
Parking Brake Pin【E】
Parking Brake Arm Spring【F】
Washer【C】
Parking Brake Spring Plug【G】
◆ Tighten:
Torque
Shift Shaft Positioning Bolt
25 N·m (2.5 kgf·m, 18ft·lb)
◆ Check:
Crankshaft and driven shaft turn freely.
If any of the shafts do not turn freely, split the crankcase
to locate the problem.
3-2-22
Bolts (M8)