Voltage Regulating Rectifi Er Inspection; Remove - Segway SNARLER ATV 2021 Series Service Manual

ELECTRICAL SYSTEM
Voltage regulating rectifi er inspection
Test and Judgment Method of Charging Voltage on Whole Vehicle
Test conditions and methods
1. Connect the product according to the normal loading
state, after the vehicle started, the speed will remain
above 2000rpm;
2. Bring a fully charged battery;
3. Use a multimeter to test the voltage at the output
terminal of the regulator

Remove

◆ Connector【A】（Disconnect）
◆ Bolt【B】and Voltage regulating
rectifi er【C】
See the table below for the determination
method of the voltage regulating rectifier
resistance:
Output resistance characteristics（unit Ω）
Output +
Output+
Y1 0.12-0.25
Y2 0.12-0.25
Y3 0.12-0.25
Output- 0.5-0.7
Output resistance characteristics（unit Ω）
Y1 Y2 Y3
∞ ∞
∞
∞
∞ ∞
0.4-0.6 0.4-0.6 0.4-0.6
Output voltage:14.0-15.0V
Qualifi ed; otherwise unqualifi ed
Output-
Connect the red pen to output +, and the
∞ ∞
black test pen to measure the remaining
terminals
Connect the red pen to Y1, and the
∞ ∞
black test pen to measure the remaining
terminals
Connect the red pen to Y2, and the
∞ ∞
black test pen to measure the remaining
terminals
Connect the red pen to Y3, and the
∞
black test pen to measure the remaining
terminals
Connect the red pen to output -, and the
black test pen to measure the remaining
terminals
14 - 14
Output voltage
B
A
C
Digital multimeter
(Diode gear)
B