Segway SNARLER ATV 2021 Series Service Manual page 299

M
VEHICLE BODY AND FRAME
◆ Use water pipe clamp pliers to remove the clamp
【M】to remove the engine exhaust pipe;
!
After removing the exhaust pipe and the water inlet
and outlet pipes of the radiator, please protect the
connection parts
◆ Use a suitable tool to remove the bolt 6, Remove the
parking adapter bracket assembly;
◆ Use a suitable tool to remove the bolts 19 and 17,
and remove the left foot guard bar combination;
◆ Use a suitable tool to remove bolts 15 and 18, and
remove left pedal bracket Components;
◆ Remove the bolts 1 and 2 with a suitable tool, and
remove the right foot guard bar assemblyTogether
◆ Remove the bolt 13 with a suitable tool and remove
right Foot support assembly;
◆ Use a suitable tool to remove the bolt 4 so that
the engine hanging assembly and The engine is
disconnected;
◆ Use a suitable tool to remove the bolt 5, remove
the suspension buffer rubber sleeve and the
hairMotivation hanging combination;
◆ Use suitable tools to remove the screw 9 and 12;
◆ Use a suitable tool to remove the nut pieces 8 and 7,
and pull out the pieces 13 and 16;
!
When pulling out the front mounting shaft bolt of
the engine and the engine mounting shaft 1, please
make sure that all parts connected to the engine are
disconnected to avoid damage to other parts
◆ Use a suitable tool to remove the bolt 14 and remove
Mounting seat
◆ Remove nut pieces 10 and 11 with a suitable tool,
and remove engine buff er block
◆ Use appropriate tooling to lift the engine assembly
out of the left side of the vehicle, and handle with
care;
13 - 19