Dashboard (Meter)Button Function Introduction; Dashboard (Meter)Disassembly - Segway SNARLER ATV 2021 Series Service Manual

ELECTRICAL SYSTEM
A
A

Dashboard (meter)button function introduction

Short press the【A】button: backlight brightness
adjustment, 5 brightness levels, from dark to bright
◆ Short press【B】button: switch between metric and
◆ Long press the【A】button: clear the subtotal
◆ Clock setting: Long press the【A】and【B】button
B
◆ To reset the total mileage: In the power-off state,
A
A
B

Dashboard (meter)disassembly

Before removing the meter, be sure to power off the
vehicle.
◆ First remove the plastic part【B】
◆ Remove three bolts【A】
◆ Pull out the connector on the back of the meter,
inch
mileage
to enter at the same time, the hour digit flashes
first, then short press the【B】button to adjust the
flashing digit, short press the【A】button to switch
to the minute digit, after setting the minute digit,
short press the【A】button to save and exit
press and hold the【A】and【B】button at the
same time, then turn on the key to power on, the
interface "CCC--" appears, adjust by pressing the
buttons: short press the left key to shift, short press
the right key to adjust the current position, Put After
adjusting to 378 "CCC--" , perform customer reset.
The condition of customer reset is that the mileage
is within 200KM and the number of customer resets
is less than 5 times.
!
remove the meter, and replace it with a new one
14 - 54