Drive Pulley Inspection - Segway SNARLER ATV 2021 Series Service Manual

A A
B B
C C
D D
F F
E E

Drive Pulley Inspection

Drive Pulley Inspection
◆ If the sheave surfaces【A】appear damaged,
replace the sheaves.
◆ Measure the inside diameter【B】and【C】of the
Bushings.
◆ If the Drive Move Pulley Bushing is damaged or
worn, replace the Drive Move Pulley.
Bushing 60×55×20 inside Diameter:【C】
Standard: 55.005 ~ 55.095 mm (2.166" ~ 1.169")
Service Limit:
Bushing 36×32×15 inside Diameter:【B】
Standard: 32.003 ~ 32.073 mm (1.260" ~ 1.263")
Service Limit:
◆ Check the Surface wear of the Counterweight
Shoes.
◆ If the Counterweight Shoes【D】are damaged,
replace them.
◆ Check the Shoes side clearance
◆ Measure the resulting clearance between the Thrust
Plate Shoes【B】and the post【C】on the movable
sheave at all three positions as shown.
★If any of the measurements are greater than the
maximum, replace all shoes with standard shoes.
Shoes side clearance:
Standard: 0.15~ 0.30 mm (0.0059" ~ 0.0118")
3-6-13
CVT SYSTEM CVT SYSTEM
55.15 mm (2.171")
32.11 mm (1.264")