Check Rear Brake Oil Cup Liquid Level; Replace Brake Fluid; Pump Out Brake Fl Uid From Brake System - Segway SNARLER ATV 2021 Series Service Manual

MAINTENANCE MAINTENANCE
A A
B B
A A
B B
C C
D D
E E

Check rear brake oil cup liquid level

The rear brake oil cup is located between LF upper The rear brake oil cup is located between LF upper
fender and front shock. fender and front shock.
◆ Park vehicle in even ground and check liquid level of
oil cup.
【 【 A A 】 】 —UPPER— highest liquid level of brake oil cup —UPPER— highest liquid level of brake oil cup
【 【 B B 】 】 —LOWER— lowest liquid level of brake oil cup. —LOWER— lowest liquid level of brake oil cup.
If fluid is lower than this level, you should refill same If fluid is lower than this level, you should refill same
brake fl uid and fasten the cap. brake fl uid and fasten the cap.
WARNING WARNING
! !
Refi ll DOT4 brake fl uid as per requirement. Refi ll DOT4 brake fl uid as per requirement.
Replace brake fl uid
Pump out brake fl uid from brake system
【 【 A A 】 】 oil cup cover of hand brake upper pump assy oil cup cover of hand brake upper pump assy
【 【 B B 】 】 oil cup of hand brake upper pump assy oil cup of hand brake upper pump assy
【 【 C C 】 】 oil cup cover of rear brake oil cup cover of rear brake
【 【 D D 】 】 oil cup of rear brake oil cup of rear brake
【 【 E E 】 】 bleeder valve bleeder valve
◆ disassemble oil cup cover 【A】 of hand brake
upper pump assembly
◆ disassemble oil cup rear brake oil cup 【C】
◆ Loosen front (rear), left (right) bleeder valve in the
brake caliper bleeder and bleed the brake calipers
【E】successively
◆ Connect transparent plastic hose of vacuum tank
with front and rear brake caliper distributions
valves respectively. The other end of vacuum tank
is connected with air source to pump out all brake
fl uids in the brake system until all fl uids in the hand
brake main cylinder oil cup and rear brake oil cup
are pumped out. Then, close air valve of vacuum
tank to cut the air source.
WARNING WARNING
! !
Brake fluid is corrosive. When turning on air nozzle and Brake fluid is corrosive. When turning on air nozzle and
discharge fl uids, pay attention not to drop any fl uid on the discharge fl uids, pay attention not to drop any fl uid on the
plastic parts or other appearance parts. plastic parts or other appearance parts.
2 - 10