Alternator Rotor Installation; Alternator Stator Removal - Segway SNARLER ATV 2021 Series Service Manual

ENGINE-ELECTRICAL SYSTEM ENGINE-ELECTRICAL SYSTEM
B B
A A
D D
F F
E E

Alternator Rotor Installation

Alternator Rotor Installation
◆ Clean【A】the inside of the rotor and the end of the
◆ Fit the rotor onto the crankshaft so that woodruff key
C C
◆ Install the alternator rotor【B】while turning the
A A
◆ Nut M18×1.5【D】
◆ Tighten:
Torque
◆ Apply a non-permanent locking agent to the Nut
Special Tool - Flywheel Holder Special Tool -

Alternator Stator Removal

Alternator Stator Removal
◆ Remove：
Left Crankcase Cover (see Left Crankcase Cover
Removal)
Bolts M6×16 (2)【E】
Bolts M6×35 (3)【F】
Alternator Stator【G】
G G
3-3-8
crankshaft.
[B] fi ts in the groove【C】in the hub of the rotor.
starter clutch gear【C】.
Nut【C】
180 N•m (18.4 kgf•m, 133 ft•lb)
【C】.
Flywheel Holder： ： E01GZ0050001 E01GZ0050001