Tooth Gap Adjustment; Disassemble; Assemble - Segway SNARLER ATV 2021 Series Service Manual

FRONT AND REAR DIFFERENTIAL FRONT AND REAR DIFFERENTIAL
D D
C C B B A A

Tooth gap adjustment

WARNING WARNING
! !
If the gear gap is not adjusted properly, it will aggravate
the wear of gear parts, resulting in abnormal gear
transmission noise, tooth surface pitting, reduced
transmission effi ciency, and shortened overall life.
【A】Hexagon fl ange bolts M8×25
【B】Active gear bearing seat
【C】Clearance adjustment pad
【D】Rear Diff erential housing

Disassemble

◆ Take four 【A】 from 【B】, and then take out 【B】
for a certain distance, then take out 【C】 on both
sides
Tool: Sleeve 10

Assemble

◆ Ta k e t h e c o r r e s p o n d i n g t h i c k n e s s o f 【 C 】
according to the gear clearance value, insert it
between 【B】 and 【D】, then install 【B】,
turn 【A】 clockwise to tighten it, reconfirm the
gear clearance, and wipe clean the gear oil spilled
around. Hexagon fl ange bolt M8×25.
Tool: Sleeve 10
Tightening torque of hexagon fl ange bolt M8X25
24N·m(2.4kgf·m,17ft·lb)
CAUTION CAUTION
! !
After replacement, please make up the gear oil, and check
whether the oil seals and sealing rings are damaged, if any,
please replace them
4 - 27
(2.4kgf·m,17ft·lb)