Camshaft Chain Tensioner Removal; Camshaft Chain Tensioner Installation - Segway SNARLER ATV 2021 Series Service Manual

ENGINE TOP END ENGINE TOP END
B B
F F
A A
B B
C C
B B
A A
A A
C C
D D
E E
F F
G G
D D
E E
Camshaft Chain Tensioner

Camshaft Chain Tensioner Removal

Camshaft Chain Tensioner Removal
CAUTION CAUTION
This is a non-return type cam chain tensioner. The push
rod does not return to its original position once it moves
out to take up cam chain slack. Observe all the rules
listed below:
When removing the tensioner, do not take out the
mounting bolts only partway. Retightening the mounting
bolts from this position could damage the tensioner and
the camshaft chain. Once the bolts are loosened, the
tensioner must be removed and reset as described in

"Camshaft Chain Tensioner Installation".

Do not turn over the crankshaft while the tensioner is
removed. This could upset the cam chain timing, and
damage the valves.
◆ Remove:
Tensioner Cap Bolt【A】and O-Ring【B】
Spring【C】
Tensioner Mounting Bolts【D】
Pipe/line Fixing Plate【E】
Camshaft Chain Tensioner【F】
Camshaft Chain Tensioner Installation
◆ Push the stopper【A】to release the ratchet and
push the push rod【B】into the tensioner body.
◆ Install
Replace the New Tensioner Gasket【A】
Tensioner【B】
Pipe/line Fixing Plate【C】and
Spring【E】,O-Ring【F】and Tensioner Cap Bolt 【G】
◆ Tighten:
Torque
Chain Tensioner Mounting Bolts
9.8 N • m (1.0 kgf • m, 87 in • lb)
Chain Tensioner Cap Bolt
12 N • m(1.2 kgf • m,8.8 ft • lb)
3-5-16
Mounting Bolts【D】