Stabilizer Linkage Removal / Installation; Stabilizer Bar Removal / Installation - Polaris Sportsman XP 1000 S 2020 Service Manual

STEERING / SUSPENSION
STABILIZER LINKAGE REMOVAL /
INSTALLATION
The following procedure details stabilizer linkage
removal / installation on one side of the vehicle.
1. Remove the end rod fasteners.
2. Remove the stabilizer linkage fastener
lower A-arm.
3. Using a 5/16" open-end wrench, hold the stabilizer
e
linkage rod and remove the upper and lower
w
bushings .
4. Reverse this procedure to reinstall the stabilizer
linkage. Torque fasteners to specification.
TORQUE
Rear Stabilizer to Linkage Fastener
35 ft-lbs (47 N·m)
Rear Stabilizer End Rod Fasteners
30 ft-lbs (40 N·m)
9.28
STABILIZER BAR REMOVAL /
INSTALLATION
1. Elevate the rear of vehicle and safely support
machine under the frame area.
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
2. Remove the (2) nuts
end rod.
q
from the
3. Remove the bushing strap bracket fasteners from
each side of the stabilizer bar.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
CAUTION
procedure. Always wear eye protection.
q
and (2) bolts
w
from each
© Copyright Polaris Inc.