Stabilizer Bar Removal / Installation - Polaris RZR PRO XP 2020 Service Manual

STABILIZER BAR REMOVAL /
INSTALLATION
REMOVAL
1. Lift and support vehicle by main frame.
2. Remove rear wheel nuts and wheels.
3. Identify / mark top side of the stabilizer bar to
reference during installation.
4. Remove the fasteners retaining the stabilizer bar to
q
the linkage on each side of the vehicle.
5. Remove the four fasteners
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel well
area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
INSTALLATION
1. Carefully install stabilizer bar through the LH wheel
well area.
NOTE
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
w
retaining the stabilizer
STEERING / SUSPENSION
5. Install rear wheels and wheel nuts. Torque wheel nuts
to specification.
TORQUE
Rear Stabilizer Bar Linkage:
44 ft-lbs (60 Nm)
Stabilizer Bar Mounting Bracket Bolts:
30 ft-lbs (40 Nm)
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
9
9.27