Propshaft U-Joint Assembly - Polaris Sportsman XP 1000 S 2020 Service Manual

FINAL DRIVE
6. Discard and replace all U-joint parts that were
removed from the yoke.

PROPSHAFT U-JOINT ASSEMBLY

1. With NEW U-joint, remove two opposing caps
end of joint to go into yoke and secure other two so
they do not fall off during installation.
2. Ensure yoke bores and ring grooves are clean before
installing new U-joint.
w
3. Place U-joint ends
e
4. Place caps into yoke bores and align with U-joint
ends by hand.
8.18
q
without caps into yoke bores.
5. Place clamp and installer adapters
OD than caps over each cap.
from
6. Tighten clamp to install caps simultaneously into yoke
bores.
7. Push U-joint side to side during clamping to seat into
caps properly.
8. Tighten clamp until both caps are flush with yoke and
one cap is past retaining ring groove
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
r
with smaller
t
.
© Copyright Polaris Inc.