Ignition Coil And High Tension Lead Replacement - Polaris Sportsman XP 1000 S 2020 Service Manual

ENGINE ELECTRICAL
IGNITION COIL AND HIGH TENSION
LEAD REPLACEMENT
NOTICE
The plug caps or coil ends are not removable. The high
tension lead (coil wire) must be replaced as an
assembly.
1. Remove the seat and upper RH side panel to access
the ignition coil.
2. Disconnect the shift linkage and remove the high
tension lead caps from the spark plugs.
3. Remove the high tension leads from the airbox
retention.
4. Disconnect the wire harness from the ignition coil.
5. Using a T20 driver, remove the screw
ignition coil and eyelet wire to the airbox.
6. Remove the coil assembly and disconnect the high
tension leads by pulling on the coil side end caps.
4.28
7. Install new spark plug wires to the appropriate ignition
coil by referencing the MAG and PTO markings on
the plug wires.
Connect the MAG wire to Ignition Coil A. Connect the
q
retaining the
8. Install the coil assembly and route the eyelet wire
between the ignition coil and the airbox.
9. Install the screw that retains the ignition coil and
eyelet wire to the airbox.
10. Upon assembly, make sure the spark plug wires are
retained by the airbox.
11. Reinstall shift linkage, upper RH side panel, and seat.
NOTICE
PTO wire to Ignition Coil B.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.