Lights; Headlights; Headlight Adjustment, Pod; Headlight Replacement, Pod - Polaris Sportsman XP 1000 S 2020 Service Manual

BODY ELECTRICAL

LIGHTS

HEADLIGHTS

HEADLIGHT ADJUSTMENT, POD

1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
3. With the vehicle in PARK, start the engine and turn
the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most
intense part of the headlight beam should be aimed 2
in. (5 cm) below the mark on the wall
weight on the seat when measuring.
5. To adjust the headlight beam, loosen the adjustment
screw on the left side of the headlight pod.
6. Adjust the headlight to the desired position, then
tighten the screw.
12.24

HEADLIGHT REPLACEMENT, POD

1. Remove the screws retaining the front half of the pod
assembly.
q
.
2. Remove the front half of the pod.
3. Disconnect the lamp
w
. Include rider
4. Remove the lamp form the housing.
If lens housing replacement is required, do so at this
5. Install new lamp.
6. Connect lamp to main wiring harness.
7. Install front half of the pod. Torque fasteners until fully
seated.
q
from the main harness.
NOTICE
time.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.