Polaris Sportsman XP 1000 S 2020 Service Manual page 409

5. Remove the Shock Seal Protector Sleeve.
6. Place the compression valve stack on the rod in the
reverse order of disassembly.
7. Place valve piston on top of the compression stack.
NOTICE
If unsure of the valve stack order, refer to "Shock
Valving" under the "Shock Service Information"
provided earlier in this section.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
STEERING / SUSPENSION
8. Place a new lock nut onto the shock rod. Torque the
new lock nut to specification.
NOTICE
Do not over torque the nut or damage to the valve stack
can occur.
TORQUE
Lock Nut
20 ft-lbs (27 N·m)
NOTICE
Make sure "Top-Out" washers are orientated as shown.
9. Front Shocks Only: Assemble the clicker valve
stack on top of the fastener and install the assembly
into the reservoir body. Tighten the valve stack
fastener securely.
9
9.43