Stabilizer Bar Removal; Stabilizer Bar Installation - Polaris RZR XP Service Manual

STEERING / SUSPENSION

STABILIZER BAR REMOVAL

1. Lift and support vehicle by main frame.
2. Remove rear wheel nuts and wheels.
3. Identify / mark top side of the stabilizer bar to
reference during installation.
4. Remove the fasteners retaining the stabilizer bar to
q
the linkage on each side of the vehicle.
5. Remove the four fasteners
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel well
area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
8.32
w
retaining the stabilizer

STABILIZER BAR INSTALLATION

1. Carefully install stabilizer bar through the LH wheel
well area.
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting.
5. Install rear wheels and wheel nuts. Torque wheel nuts
to specification.
TORQUE
Rear Stabilizer Bar Linkage:
70 ft-lbs (95 Nm)
Stabilizer Bar Mounting Bracket Bolts:
20 ft-lbs (27 Nm) + 90°
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
NOTE
and stabilizer links.
© Copyright Polaris Industries Inc.
Center