Scanning With The Talkman A730/A730X Device; A730 / A730X Scanner Configuration - Honeywell A700 Hardware Reference Manual

Scanning with the Talkman A730/A730x Device

See the Compliance Section of this document for Laser and Imager Compliance and Precaution
information.
The scanner can only be used at points in the task where it is allowed, such as a check digit or
product verification prompt.
CAUTION
The scanner is designed for occasional use and should not be used more than six times per
hour. Other scanning devices more suited to hands-free and eyes-free scanning should be
used for optimum performance.
1. Hold the Talkman A730/A730x in a "handshake" grip with the scanner pointing away from
you.
2. Position the device so that the scanner is 4 to 36 inches away from the bar code you want
to read. Note that scan accuracy may decrease at greater distances.
3. Press and hold the round black button to activate the scanner.
4. Direct the lighted aiming frame so that it completely contains the bar code.
5. When a scan is successful, the aiming frame will turn off and you will hear a beep in the
headset.
NOTE
The beep that signals a scan is enabled by default but can be disabled by setting
EnableBeepOnBarcodeScan to 0. The beep volume is controlled by the device volume
and can be adjusted with the Plus (+) and Minus (-) buttons on the device.

A730 / A730x Scanner Configuration

The A730/A730x scanner parameters are grouped into three categories:
Symbology specific parameters enable, disable, and configure the specified symbology.
l
Imager generic parameters affect all symbologies.
l
Voice Device and Headset Hardware Reference Guide 32