Connecting Peripherals To A Talkman Device; Disconnecting Peripherals From A Talkman Device; Scanner Connections For Wired Scanners - Honeywell A700 Hardware Reference Manual

Connecting Peripherals to a Talkman Device

1. Attach the cable to the device as shown in the image below.
2. Make sure the peripheral is off.
3. Connect the cable to the peripheral.
4. Turn the peripheral on.

Disconnecting Peripherals from a Talkman Device

CAUTION
Never pull on the cable or twist the connector to disconnect it from the device. Doing so will
damage the cable and connector, and invalidate the headset's warranty.
1. Grasp the connector.
2. Press the connector's release lever.
3. Tilt the bottom of the connector off the device.
4. Lift the connector up and off the device.

Scanner Connections for Wired Scanners

Scanners typically require two connections, one for data and one for power. The data connection
is typically a DB9. The only pins used by the system are pins 2 (receive), 3 (transmit) and 5 (signal
ground). Power connections can be unique, and voltage ranges can vary.
Most scanners powered by 5V DC include a modular cable that can be refitted to work with the
system.
Vocollect offers cables with the TCO on one end and an unterminated 5V DC connection on the
other. This may easily be re-terminated and connected to a scanner.
Voice Device and Headset Hardware Reference Guide 198