Pairing By Voiceconsole Pairing; More About Srx2/Srx3 Pairing Modes - Honeywell A700 Hardware Reference Manual

Icon Status
A wireless headset is not paired to the device
The device is searching for a headset
The device is paired with a headset but not yet connected
The device is connected to the headset

Pairing by VoiceConsole Pairing

The VoiceConsole pairing method should only be used if the device/headset pairing will be
performed once and never changed. While manual pairing can also result in this permanent
pairing, VoiceConsole eliminates the device inquiry step and begins paging immediately for the
Bluetooth address.
Prerequisites:
The headset is powered off.
l
The device is not in a charger, and there is no wired headset connected to it.
l
The device is in sleep mode — not in use running an application.
l
The device is Bluetooth ready with Bluetooth connection features enabled.
l
1. In VoiceConsole, click Devices and select the device for the pairing.
2. In Device Actions, select the actions for pairing to a peripheral, and complete the pairing.
See VoiceConsole help for detailed instructions.
TIP
The pairing can be performed with the device powered off or while the device is
running an application. When the device powers up or goes into sleep mode, the
paging process begins.
3. Place the headset in pairing mode. The SRX2 and SRX3 headsets are automatically in
pairing mode after being powered on.
4. When the two connect, the headset will play ascending connect tones. The pairing
confirmation step is skipped because the pairing was specified by the user.
5. Press the Play/Pause button to begin working.

More about SRX2/SRX3 Pairing Modes

When a headset is in pairing mode it is ready to respond to any inquiries about its Bluetooth
services. The inquiring device uses this response to determine if it wants to pair with the headset.
Voice Device and Headset Hardware Reference Guide 132